Set Of 4 Oxygen Sensors Up+Down For 2004 2005 2006 Toyota Sienna LE CE 3.3L V6

Description: Product Description Specification: * Line length:350mm 400mm 535mm * 4 wire configuration * Interchange Part Number: 234-9012 234-9042 234-4168 234-4512 * Package Include 4 pcs x Oxygen Sensor Warranty: 5 years Fit Vehicles: Toyota Sienna 3.3L V6 2004 2005 2006 Please see compatibility chart. ”Please check the part number and item pics clearly, confirm suited to your needs.” （It is best to note that your car model is in the order when you place an order, so that we have dedicated technicians to help you check whether the product you have purchased matches your car model. Thank you） Must know before buying: The following information is for instructional and guidance reference only. We try and make them as accurate as we can.If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below. If the sensor is good, further diagnosis is required. There're many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any feedbacks. 1. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty. 2. 20% restocking fee is required if buyer bought wrong items due to not paying attention to fitment information and ask for return. The Price, Quality & Functionality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered. Q: How do I know the O2 sensor is good or not? A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation. Use a 10-mega ohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes. Goes above range between 0.1 and 0.9 volt Remains below 0.5 volts Stays fixed at a particular voltage

Price: 76.88 USD

Location: Perth Amboy, New Jersey

End Time: 2024-09-27T12:16:22.000Z

Shipping Cost: 0 USD