Description: Prestone Products AF-KIT-6 Flush 'N Fill Radiator Cleaner Kit product details . Refer to the vehicle manufacturer for the recommended change intervals, cooling system capacity, recommended concentration, and specific cooling system service instructions. If using a cooling system cleaner; run the cooling system cleaner prior to installing this kit. Collect used antifreeze/coolant and dispose according to local laws and regulations. Read entire instructions before beginning. To Install:. 1. Make sure the engine is cool and carefully loosen the cooling system pressure cap to release any pressure, and then retighten the cap. 2. Identify the heater inlet hose and locate a relatively straight section of the hose away from the hot exhaust system. 3. Install the Flush & Fill Tee. a. Cut the heater hose in the identified straight section of hose. (in step 2). b. Slide the Hose Clamps over two ends of the cut hose. c. Install the Flush & Fill Tee that provides a snug fit in the hose. (discard the unused tees). d. Tighten the hose clamps. Do not over tighten. To Back-Flush:. 1. Make sure the engine is cool and remove the cooling system pressure cap and the flush & fill tee cap. 2. Attach the Back-Flow Preventor Coupler to the flush and fill tee and garden hose. (Black end to the flush & fill tee, Yellow end to the garden hose). 3. When appropriate attach the Splash Deflector Tube into the cooling system fill neck. 4. Open the radiator drain. 5. After the radiator has drained, turn on the water supply and verify that water is flowing from the cooling system fill neck and radiator drain. Be sure that everything is away from the rotating parts of the engine before proceeding. 6. Start the engine and set the heater controls to high. Run at idle until the water flowing from the fill neck and radiator drain runs clear. This should take about 5 minutes, but Never Run Longer Than 10 minutes. 7. Shut off the engine and turn off the water supply. Remove the splash deflector tube, garden hose, and backflow preventer coupler. After the radiator has drained, close the radiator drain and install the flush&fill tee cap. To Fill:. 1. Determine how much Prestone Antifreeze/Coolant concentrate to install to achieve a minimum 40%, maximum of 70%. 2. Fill the system with the determined amount of Antifreeze/Coolant (in step 1) and top off with water. (Refer to the vehicle manufacturer for fill procedures). 3. If the system has an overflow reservoir, flush out the reservoir with water and fill to the proper level with the correct concentration Prestone Antifreeze/Coolant. 4. Start the engine and set the heater controls to high. Run at idle for 10 minutes after reaching operating temperature while checking for leaks. 5. After 1 week of normal use check the coolant concentration with an antifreeze tester and top off with Antifreeze/Coolant and/or water as needed.
Price: 7.99 USD
Location: New York, New York
End Time: 2024-09-05T10:10:27.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: unbarnded
Expiration Date: no
Model: no
UPC: does not apply
MPN: 234567890
Country/Region of Manufacture: United States
California Prop 65 Warning: see description
