2 Rear Boosters for Star Bird Milton Bradley 3D Printed Replacement Parts

Description: Replacement booster for a Star Wars Milton Bradley Star Bird Craft. Includes two (2) boosters. For vintage Star Bird (1970's) One color available (gray). Reproduction (3D Printed) Ships FAST from Port Orange, FL, USA- Ships same day before 2pm. The Star Bird manual describes it as "THE AMAZING SPACESHIP with realistic engine sounds and flashing laser blasts". The toy was constructed in three main pieces: the front inner hull which held the electronics and front lasers, the front outer hull (a thin plastic shell over the inner hull), the main body consisting of the center stalk like section and wings. A molded plastic engine piece fit into the rear of the main body and was removable. The toy is only used in three configurations: the Star Bird which consists of all available pieces, the Star Bird Fighter which is mostly only the front hull attached to the bare engine piece, and the Star Bird Orbiter which is the main body without the front outer hull. When turned on the Star Bird mimics an engine sound. If the toy is pointed upwards the sound would be altered by a ball bearing switch to imply a Doppler effect acceleration or taking-off, while a nose down orientation gives the sound of decelerating engines. A button at the rear of the cockpit activates the LEDs at the front of the toy, along with a blast noise, to simulate the firing of its lasers. The button was designed to be pressed by the thumb while the ship was held by the main body or engine piece (in "dragster" configuration). Two simple, detachable drone-like "Interceptors" are provided at the end of each wing. Star Bird also had a rotating laser turret which doubled as an escape-pod/orbiter-type ship. Very much to the dismay of current-day collectors the twin lasers from the turret are often missing in today's offerings of the play set.

Price: 14.99 USD

Location: Port Orange, Florida

End Time: 2024-03-06T02:34:42.000Z

Shipping Cost: 0 USD